1. Solar cell solar street lamp solar panel installation specification

Solar panel Installed with the light board bracket, the four screws need to be fastened. It should be noted that the rear side of the solar panel should not be oriented upwards. (Note: During the pole process, pay attention to the solar panel in the south direction, avoid installing under the tree or near other obstructions)

Second, LED lamp installation specifications

LED lamps Before installing with the lamp arm, first thread the cable of the lamp into the arm of the lamp, pierce it at the top of the pole, and then install the LED lamp on the arm of the pole. The screw is fastened, and the light source needs to be installed after the lamp is installed. Parallel to the flange, ensure that the light source of the LED light fixture is parallel to the ground after the pole is raised for better illumination.

Three, lithium battery intelligent storage and control machine installation specification

Lithium battery intelligent storage and control integrated machine and light board bracket installed together, four screws need to be tightened, need to pay attention to lithium battery intelligent storage and control The machine outlet position should not be oriented upwards.

4, Lithium battery solar street light wiring method

1, first connect white cable (LED lamp head) Note: The red cable is connected to the red cable, the black cable is connected to the black cable, and the 12V system distinguishes between the positive and negative terminals.

2. Turn on the system switch (the system indicator lights up). The LED head lights up after 20 seconds.

3. Connect the black cable (solar photovoltaic panel) and turn off the LED head for 20 seconds. Note: The red cable is connected to the red cable, the black cable is connected to the black cable, and the 12V system distinguishes between the positive and negative terminals.